Do that, and I would suggest you pick the username "root." I'm not sure it actually pays attention to the username field here, even though you're allowed to change it. The first thing you'll notice after grabbing an IP address, browsing to, and logging back into your newly DD-WRT'ed Nighthawk is that it tells you that you have to change your username and password, which are currently insecure default. That's really all there is to installing Kong's DD-WRT build on a Nighthawk after ignoring the version number mismatch, it installs and reboots the router automagically in just a minute or two, and you're ready to rock, with the router on 192.168.1.1 and handing out addresses in the 192.168.1.0/24 range on your LAN. (You might get a warning that the firmware you've selected is older than your current firmware, but that's just a "misfeature." It compares version numbers, but the version number history for Kong's DD-WRT mods is completely separate from the version number history for Netgear's OEM firmware.) CHK file I'd extracted from the ZIP, and that was that. With that done, I logged into the Nighthawk's Web interface and went to Advanced -> Security -> Router Update, browsed to the. That was a ZIP file, which I extracted into my Downloads directory. (You do need to create a free-as-in-beer account before you can download any of the firmware from the site.) From there, I clicked Downloads, changed the Search Downloads combo box to "R8000" (the internal, non-market-y codename of my Nighthawk X6), and downloaded the latest "DD-WRT Kong Mod" for the router. I fired it up, browsed to, and logged in. I had a Netgear Nighthawk X6 on hand already (the very same one I used in the first Homebrew router article). A disturbing number of them brick a few routers along the way, though, so the heck with that: Netgear is actually supporting open source, so here's me supporting them right back. Thousands of people do exactly that, of course. Typically, the vendor doesn't support it, doesn't want you to do it, and you have to put the router into a TFTP firmware flash mode and/or use some sort of stack-smashing hack to break out of the OEM firmware in the first place. It's certainly possible to install DD-WRT or OpenWRT on a non-Netgear consumer router, but it's generally a giant pain in the ass and a good way to potentially brick your router. This is extremely cool, not least because it means that you can install firmware from myopenrouter directly onto a supported Netgear router using the router's own Web-based interface. I'm going to just talk very specifically about getting it running on a Netgear Nighthawk here for good reason: Netgear directly runs, where they actually collaborate with open source developers who are adapting builds of open source firmware for installation on Netgear routers. You can also run OpenVPN on all sorts of consumer routers, running either OpenWRT or DD-WRT. When not constrained by the actual network connection, the Homebrew will push > 200 Mbps of OpenVPN traffic. The results you're seeing-80 Mbps down and 5-8 Mbps up-are the limits of my Internet connection and/or the stuff my wife, kids, and various computers were doing while I ran the test. Enlarge / This is a run on the Homebrew, powered by a Celeron J1900, using the nice-and-paranoid combination of AES-256-CBC/SHA512.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |